November 17, 2026
How to sow ice plant seeds and get them through winter
Hardy ice plant (Delosperma) seed needs light to germinate. You press it onto the surface of a damp, gritty mix and leave it uncovered somewhere warm and bright. Each seed is about the size of a dust grain, with little stored food inside. A seedling that starts under even a thin layer of soil runs out of energy before it reaches the light. Start the trays indoors several weeks before your last frost. The harder part comes later, in the seedlings' first winter. Cold, wet soil around the crown kills more young ice plants than the cold alone does.
1. Pick a sowing date from your yard's last frost
Count back several weeks from your last frost so the plants are sturdy when they go out. Use your own yard's date. A published date comes from a wider area, and cold air drains into low spots on still nights and holds frost there later. Our published last frost is April 28. Against the forecast, our station learned an offset of -7°F, which pushes our effective last frost out to May 20. In 2026 the final spring frost in our garden arrived on April 30. If your yard sits in a cold pocket, shift the whole schedule later. The microclimate checker compares nearby home weather stations with the forecast model over recent nights and returns a range for your area.
2. Fill a tray with a gritty seed mix
Cut a fine seed mix with perlite, grit, or coarse sand. The coarse pieces leave open pores, so water drains through and air stays around the young roots. Wet the mix fully and let it drain before you sow. Water poured over the top after sowing washes the seed into dark crevices. Our guide to seed starting mix covers the base mix.
3. Press the seed onto the surface
Tip the seed onto a folded sheet of paper and tap it across the tray. A pinch of dry sand mixed in shows you where the seed landed. Press the surface lightly with your palm so each seed touches damp mix. Leave it uncovered.
4. Cover the tray and set it somewhere warm and bright
A clear lid or plastic wrap holds humidity at the surface, where an uncovered seed would otherwise dry out. Put the tray under grow lights or in a bright window. Add gentle bottom heat if the room runs cool, because cool mix slows germination or stops it. Keep a covered tray out of hot direct sun, since the air under the lid overheats fast.
5. Water from below
Stand the tray in a shallow dish of water and lift it out once the top of the mix turns dark. Overhead water knocks loose seed around and keeps the surface wet for fungi. Our guide on bottom watering explains how long to leave it.
6. Remove the cover once seedlings appear
Take the lid off when most seeds have sprouted. Damping-off, a fungal rot that topples seedlings at the soil line, thrives in still, humid air around thin stems. From here, let the top of the mix dry between waterings. The adult plant stores water in its leaves and prefers dry roots.
7. Plant out into the driest spot you have
Harden the seedlings off over several days of longer outdoor visits. Plant them after your adjusted last frost, in full sun. Good spots include a slope, a raised bed, a rock garden edge, or a gap in a stone wall. Each one lets gravity pull water away from the crown.
Drainage varies more between beds than most of us expect. From mid-July through early September, the moisture in our raised bed 1 stayed between 39% and 54%. Our ground bed covered a wider range in those weeks, from 32% up to 62%. July brought 10.89 inches of rain. Raised bed 1 stands 24 inches deep above grade, so gravity pulls water down and out of it. Our ground bed sits only 8 inches deep on native soil and drains no faster than the subsoil beneath it. We would put ice plant in the raised bed. The fast-draining soil guide covers what to add to a slow bed.
8. Watch how wet the bed stays going into winter
In cold weather the plant barely draws water, so water that fills the soil pores stays there. Saturated soil starves the roots of oxygen, and rot fungi then work into the crown. This year our coldest night bottomed out at 3°F. Hardy ice plant handles hard cold far better in dry soil than in wet.
The watering guidance on the Today screen gives you a garden-level read on how often the ground gets soaked. Rain of 5 mm or more in the last three days turns the watering guidance to covered. A late fall that reads covered most days gives your ice plant bed few chances to dry. On Pro, a soil probe mapped to the bed records its readings over time. It sends a dry alert when the two most recent readings are both below 25%. Watch how fast the readings fall after a soaking. A bed that drops back soon after rain drains well. A bed that sits near its wettest reading for days is holding water around the crowns.
If the bed stays wet, lift the young plants before the first frost. Replant them higher in a mound of grit, or pot them up and keep them in a cold, bright, sheltered spot. Our offset puts our effective first frost at September 30. The first one we recorded in 2025 arrived on October 3. Cuttings make a good backup, and our guide on propagating ice plant before first frost covers the timing.
What can go wrong
- Nothing sprouts. The seed got buried or the room ran too cool. Sow again on the surface and add bottom heat.
- Seedlings fall over at the base. Damping-off took hold in wet mix and still air. Vent the tray sooner and water only from below.
- Seedlings stretch thin and pale. They lack light and are reaching for it. Move the lights closer or the tray to a brighter window.
- Plants vanish over winter. Crown rot set in from wet soil. Next year, plant into a raised or sloped spot.
- Frost hits newly planted seedlings. They went out by a published date in a yard that runs colder. Plant by your adjusted date instead.
Each probe measures moisture only at the depth and spot where it sits. It cannot see meltwater pooling around a crown at the surface after a thaw, so check the bed with your eyes after snow melts.
Test your planting spot before you sow. Dig a hole a trowel deep the day after a heavy rain. If water stands in the bottom, build the spot up with grit or pick another one before the seedlings go in.
Common questions.
- How do you plant ice plant seeds?
- Press them onto the surface of a damp, gritty seed mix and leave them uncovered. Cover the tray with a clear lid to hold humidity, then set it somewhere warm and bright. Water from below until the seedlings appear. Then take the lid off.
- Do ice plant seeds need light to germinate?
- Ice plant seeds need light to germinate, so they sit on the surface with no soil over them. Each seed is so small that it holds little stored food. A buried seed runs out of energy before its shoot reaches the light.
- When should I start ice plant seeds?
- Start them indoors several weeks before your yard's last frost, and plant them out after that frost passes. Use a date adjusted for your site, because cold air pools in low spots and keeps frost there later in spring. Our published last frost is April 28, and the offset our station learned pushes our effective date to May 20.
- Is ice plant hardy in winter?
- Hardy ice plant takes hard cold well when its roots stay dry. In winter the plant draws up almost no water, so wet soil stays wet around the crown and rot sets in. Plant it in the fastest-draining spot you have, such as a slope, a raised bed, or a rock garden edge.
Related guides
How to sow snowdrop seeds and let winter chill them
Sow snowdrop seeds fresh in an outdoor pot, let summer warmth and winter cold break dormancy, and check how cold your yard gets.
What winter garden seeds you can sow depends on your yard
How the coldest night your yard reaches decides which winter garden seeds germinate and survive, and how to find that low before you sow.
When to sow Carpet of Snow sweet alyssum seeds before frost
Sow Carpet of Snow sweet alyssum seeds on the surface a few weeks before your yard's last frost, and cover seedlings on freezing nights.
Free planting tools
- When to plant shows the last date to sow each crop before your fall frost.
- Microclimate checker shows how much colder or warmer gardens near you ran than the forecast low.
- GDD estimator adds up a typical season's heat and shows which crops can ripen where you are.
